![]() cables there are literally 1000's of sources for low cost ,well constructed speaker wire.Īnother user noted using CSW Ambiance. Monoprice is a good source as well as Tartan/bluejeans. another set of direct radiating speakers ( Ensemble sats - without the sub) or maybe a set of S200 or S300 - set to bipole or Directįrom the images you posted it looks like your speaker cable is oxidizing, you might want to get yourself new wire. If you're already set up for 5.1 then just add the missing 2 channels. You might get similar results from the old Model 17 speakers as well, based on their rep. I find they actually make a pretty good timbre match for the Definitive Technology ProCinema 1000's that replaced the Ensembles, although they are lacking in other areas compared to the more modern designs and will soon be replaced. I have since upgraded the entire system - except the Ambiances, which are still functioning as my rear surrounds. These are wonderful sounding small speakers, similar in timbre to the Ensembles and the Model Six. I think I paid $40 for the pair, shipped. When I went 7.1 I found a pair of CSW Ambiance speakers on eBay (these were the ones in cabinets, before CSW started using "Ambiance" for their in-wall speakers). I can also connect directly to the amp using speaker wires, but I cannot find the old connector that came with sub to do this.For a good while I had a 5.1 system consisting of two sets of original Ensembles (so, four bass modules and four sats) as the left and right mains and left and right surrounds, plus a Center Channel (identical to the Ensemble sat) and a BassCube 15. Maybe I fried the controller? Any help is welcome, including repair starting points. Can anyone help please? One other thing, I did hook up various power supplies thinking they were the correct ones and this caused a red light to come on and a whirring noise in the control module. No hum, no buzz, nothing when I unplug one end and touch with my finger, nothing. After all this, still no sound at all from P500 subwoofer. Also tried different RCA cables to see if sub cable was bad. ![]() Marantz amp appears to be working fine, have monster sub cable from pre out to sub in on control module, phone cable works, tried with 3 different cables to be sure. It gets power (blue light on), fuse looks good, bottom of case warms up, control module turns on with replacement power supply and turns green, though sometimes stays yellow when on "auto" setting. Hi guys, I'm having a similar problem with my old Cambridge Soundworks P500 subwoofer. Anyone know where I can source a new speaker wire connector for back of subwoofer? Thanks! I can also connect directly to the amp using speaker wires, but I cannot find the old connector that came with sub to do this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |